FRP rebar making machine

This line mainly consists of roving racks,resin bath,winding,heating, traction device cutting saw and racks for finished produc

This line mainly consists of yarn support, dipping glue slot, winding, dry oven, haul-off machine, cutting saw and tilt tipping device.

Yarn support: used to place the yarn spool, adopts the welding structure of steel plate, steel pipe and angle iron.

Dipping glue slot: welded by stainless steel material, there is press roller inside to make the roving dip in the resin sufficiently.

Winding device: adopts gear wheel to drive the roller turn around the products, and wind the thread. This device adopts frequency conversion speed-regulated mode, adjust the rotate speed stepless.

Dry oven: adopts cast aluminium heater, intelligent temperature controller to control the temperature. The heating box adopts mesh structure and it is easy to open it and clean the dropping resin, filled with insulation materials inside.

Technical parameter:

Working voltage	380V/50HZ	Air pressure	0.4-0.6Mpa
General power	30Kw	Center height	1000mm
Number of winding heads	2	Winding diameter	Max. 26mm
Winding rotation speed	9-95rpm	Traction force	Max. 40Kn
Traction speed	0.1-1m/min	Clamping width	500mm
Clamping length	1200mm	Cutting speed	2850rpm
Cutting range	(W*H) 500*85mm	Length setting mode	Limiting switch
Cutting journey	700mm	Dimension	22000*1850* 1450mm

FRP rebar making machine